SKU GMX 400 Category

Magnetic Fluid Conditioner For 1/4″ to 1/2″ Tubing or Pipe

Description

APPLICATIONS

Primary Applications:

Residential and commercial applications wherever hard water is present (fuel lines, swamp coolers, commercial ice machines, fountains, printing equipment, commercial dishwashers).

Non-Ferrous Pipes Only:

Install the Model 400 only on a straight section of non-ferrous (PVC, rubber plastic, copper , or stainless steel) pipe or tubing–not on steel or iron . Don’t place it on any tubing to which the magnets stick. The penetration of a magnetic field through iron or steel (except for stainless steel) pipe is minimal, because the magnetic field travels along the exterior of such tubing preventing it from reaching the fluid. In such cases, replace a 12″section of steel tubing with non -ferrous tubing and then install the Model 400 on that section.

Stabilization Period:

On water systems: for a few weeks after installing the Model 400 you may notice an increase in water turbidity (cloudiness) this is because scale is being removed from the system. During this stabilization period, carefully monitor filters, tanks, and sumps each week, and drain or clean them as needed.

On fuel systems: a temporary decrease in mileage and an increase in emissions may be noted after installing the Model 400. This is a temporary condition resulting from the removal of accumulated deposits from the fuel system and combustion chambers.

GMX Model 400 is used for both water and fuel treatment.
These units go on 1/2 inch diameter lines.

For water treatment we use these units on commercial coffee makers, feed lines to toilets, dishwashers and ice makers, plus on drip irrigation systems and swamp coolers. These units treat hard water and help reduce scale buildup.

For fuel treatment we use these units on the fuel lines on vehicles, farming equipment, propane lines to heat sources and barbecues, natural gas lines to water heaters or other household natural gas treated appliances, etc. When the fuel goes through the magnetic field the hydrocarbons are fractured that’s everything burns more efficiently. Fuel savings can range between five and 25%, pending upon the application.

Reviews

There are no reviews yet.

Be the first to review “Magnetic Fluid Conditioner For 1/4″ to 1/2″ Tubing or Pipe”

Your email address will not be published. Required fields are marked *