Magnetic Fluid Conditioner For 2″ to 14″ Tubing or Pipe

Description

APPLICATIONS

Primary Applications

Residential, Commercial, Industrial, and Agricultural applications wherever hard water is present.

INSTALLATION

Please Note: Each Model 8000 set consists of two separate pieces. One piece has two north pole magnets. This is the side covered by the GMX label. The other piece has two south pole magnets. A system consists of one or two sets, held to the pipe by a common band. There should always be a 1″space between units.

Installation on 2″ to 4″ Pipe:

Install four sets 1″ apart . The sets must be placed so that the north pole pieces are lined up with each other on the same side of the pipe, and the south pole pieces are in line with each other on the exact opposite side of the pipe.

Installation on 5″ to 6″ Pipe:

Install seven units 1″ apart. The sets must be placed so that the north pole pieces are lined up with each other on the same side of the pipe, and the south pole pieces are in line with each other on the exact opposite side of the pipe.

Installation on 6″ to 14″ Pipe:

Install seven to 15 units depending on the diameter of the pipe. The north pole pieces of both sets in each unit must be placed side-by-side on one side of the pipe. The south pole pieces of both sets in each unit must be placed side-by-side on the opposite side of the pipe. (For example, if the two north pole pieces in the unit were placed at the 11:00 and 1:00 positions, then the two south pole pieces would be placed at the 5:00 and 7:00 positions.)

Non-Ferrous Pipes Only:

Install the Model 8000 only on non-ferrous (PVC, plastic, copper,or stainless steel) pipe or tubing–not on steel or iron pipe. Don’t place it on any pipe to which the magnets stick. The penetration of the magnetic field through iron or steel (except for stainless steel) pipe is minimal. In effect, the magnetic field travels along the exterior of such pipes preventing it from reaching the fluid. In such cases, replace and 18″ to 24″ section of steel pipe with either copper or PVC pipe, and then install the Model 8000 on that section.

Stabilization Period:

For a few weeks after installing the Model 8000 you may notice and increase in water turbidity (cloudiness). This is because scale is being removed from the system. During this stabilization period, carefully monitor filters, tanks, and sumps each week, and drain or clean them as needed.